- 35% Off Industrial and Drone Parts.
- Free carbon neutral shipping on India orders ₹ 2000+.
End of Time:
:
:
:
0
0 items
₹0.00
No products in the cart.
- Input voltage: DC12-24V
- Amp Chip: TPA3116D2
- Output impedance:4~8 ohm Speaker
- Current: ≥3A
- Output power: 80W*2
- Adopt a TPA3116D2 high-performance power amplifier chip.
- With total volume, subwoofer volume, and stereo volume control knobs.
Add to Wishlist
Add to Wishlist
- Input: 5V(DC)
- Operating current (without signal output state): less than 15 mA
- Operating current (with signal output state): less than 40 mA
- Chip: KT403A
- Chip LDO output voltage: 3.3 V
- Chip output current: 100 mA(at Max.)
Add to Wishlist
Add to Wishlist
- Working Voltage: 3.⅗V
- Working Current (@5V, 25℃)
- Standby: 25-30mA
- Recording: 29-35mA
- Playing: 110-150mA
- Working Current (@3.3V, 25℃)
- Standby: 23-25mA
- Recording: 25-30mA
- Playing: 70-150mA
- Working Temperature: 0~85℃
- Size: 40x20mm
- Weight: 31.5g
Add to Wishlist
Add to Wishlist
- Brand: Seeed Studio
- Supply voltage: 3.3V +-0.2V
- Sound Pressure Level: 140 dB SPL
- Sensitivity: -26(dB, dBFS @1kHz 1Pa)
- 6 MEMS microphones: MSM261S4030H0
- Supply current: >750mA(Full brightness)
- Range of working temperature: -30 ~ 85C
Add to Wishlist
Add to Wishlist
- Signal Type: Analog signal
- Power Supply: 3.3V/5V
- Directivity: All-round
- Sensitivity: -42dB
- S/N Ratio: 59dBA
- Frequency Range: 100Hz~8KHz
Add to Wishlist
Add to Wishlist
- Work voltage:DC 12V-28V
- IC:TPA3118D2
- Power interface:DC 5.5*2.1mm socket
- Audio channel:2CH
- Output power:45W*2
- Input current:>3A
- Output impedance:4ohm-8ohm
Add to Wishlist
Add to Wishlist
- Module Type: TDA8932 35W
- Operating Voltage: Single DC10 ~ 30V
- Recommended Voltage: 24V
- Current: Above 2A Switching Power Supply
- Output Power: 35W x 1
- Speaker Impedance: 4-8 ohm, 8 ohm best
- Circuit configuration: Mono BTL Output
Add to Wishlist
Add to Wishlist
- Item Type: Amplifier Board
- Model: HF69B
- Supply Voltage: 5VDC or 3.7V lithium battery
- Applicable Speaker Impedance: 4 ohms, 6 ohms, 8 ohms
- Charging Interface: When using a lithium battery, the charging interface can be charged with a 5 volt power supply or a mobile phone charger to charge a single lithium battery.
Add to Wishlist
Add to Wishlist
- MP3 file format:
- support all bit rate 11172-3 and ISO13813-3 layer3 audio decoding
- Sample rate support (KHZ): 8/11.025/12/16/22.05/24/32/44.1/48
- support Normal, Jazz, Classical, Pop, Rock and other sound effects
- UART interface: standard serial port, TTL level, baud rate can be set
- Input voltage: 3.2V-5V (best 4.2V);
- Rated current: 20ma
Add to Wishlist
Add to Wishlist
- Output Voltage: 12.6 VDC
- Balance connector: JST
- Discharge connector: Nylon Female T Connector
- High energy density
- Inbuilt (BMS) battery protection circuit
Add to Wishlist
Add to Wishlist
- Charge connector: DC 5.5mm Female connector
- Discharge connector: Nylon Female T Connector
- Maximum Output Voltage: 12.6 VDC
- High energy density
- Good consistency and low self-discharge.
- Long life with full capacity for up to 500 charge cycles
- Inbuilt (BMS) battery protection circuit
Add to Wishlist
Add to Wishlist
- Output Voltage: 12.6 VDC
- Discharge connector: Nylon Female T Connector
- Long life with full capacity for up to 500 charge cycles
- Inbuilt (BMS) battery protection circuit
- Dimensions: 7 x 6 x 3mm
- Weight: 200g
Add to Wishlist
Add to Wishlist
- Charge connector: DC 5.5mm Female connector
- Discharge connector: Nylon Female T Connector
- Maximum Output Voltage: 12.6 VDC
- High energy density
- Good consistency and low self-discharge.
- Long life with full capacity for up to 500 charge cycles
- Inbuilt (BMS) battery protection circuit
Add to Wishlist
Add to Wishlist
- Nominal Capacity (mAh): 2200
- Charging Connector: JST-XH connector
- Discharging Connector: Nylon Female T Connector
- Nominal Voltage (v): 11.1
- Max Charging Voltage (v): 12.6
- Inbuilt (BMS) battery protection circuit
Add to Wishlist
Add to Wishlist
- Maximum Output Voltage: 12.6 VDC
- Connector: DC Jack Male & Female
- High energy density
- Good consistency and low self-discharge.
- Long life with full capacity for up to 500 charge cycles
- Inbuilt (BMS) battery protection circuit
Add to Wishlist
Add to Wishlist
This battery pack is made of best quality tested ICR 18650 2000mAh 20C Lithium-Ion Batteries and BMS circuit. It is very small in size and weight compared to Ni-Cd, Ni-MH, and Lead Acid Batteries. With the inbuilt Charge protection circuit, the battery pack can be directly charged with the DC power Adapter, so need not use the specialized battery chargers and worry about overcharging.
Add to Wishlist
Add to Wishlist
Basic Components – Resistors | Capacitors | LEDs | Inductor | Varistor | Breadboard | Oscillator
Important links
Need Help?
+91 7231900002 (whatsapp)
Monday – Friday: 9:00-20:00
Saturady: 11:00 – 15:00
Customer Service
- -5% for all order in this week Shop now
- Free delivery for all orders over ₹ 2000