Features:

1. Omnidirectional circularly polarized antenna
2. Polarization – RHCP
3. Center frequency: 5.8 GHz
4. Every low standing wave smooth omnidirectional radiation receiving mode

Package Includes:

1 x 5.8G 2.8dBi RHCP RP-SMA Lollipop Antenna(Long)

Features:

1. Omnidirectional circularly polarized antenna
2. Polarization – RHCP
3. Center frequency: 5.8 GHz
4. Every low standing wave smooth omnidirectional radiation receiving mode

Package Includes:

1 x 5.8G 2.8dBi RHCP RP-SMA Lollipop Antenna

Features:

1. Omnidirectional circularly polarized antenna
2. Polarization – RHCP
3. Center frequency: 5.8 GHz
4. Every low standing wave smooth omnidirectional radiation receiving mode

Package Includes:

1 x Lollipop 5.8G 2.8dBi RHCP SMA Antenna(Long)

Features:

1. Omnidirectional circularly polarized antenna
2. Polarization – RHCP
3. Center frequency: 5.8 GHz
4. Every low standing wave smooth omnidirectional radiation receiving mode

Package Includes:

1 x 5.8G 2.8dBi RHCP UFL Lollipop Antenna

This 3DR Radio Telemetry 433MHz 500mW Set allows you to link to a flight controller to a USB or UART-equipped device such as a computer, laptop or tablet supporting a USB connection (OTG). The new V2 radios, no longer have a separate Air/Ground module, as both transceivers can use UART or USB connections and supports both modes. The Radio set not only lets you see live data, such as live GPS position overlaid on a map, system voltage, heading, waypoint navigation even artificial horizon and so much more.

Using open-source MAVlink-based ground station software, you can even fly your aircraft with a joystick via your computer and update settings live! Or just use it for your DIY projects that need a wireless Serial interface. This kit offers a great low price, longer range, and superior performance. The system utilizes the 433MHz band and provides a full-duplex link using HopeRF’s HM-TRP modules running custom, open-source, firmware.

Features & Specifications

1. 1. MAVLink protocol framing status documents
   2. Frequency modulation and Spread Spectrum (FHSS)
   3. Self-adaption to time-division multiplexing
   4. Support LBT and AFA
   5.  Configurable duty cycle
   6. Built-in error-correcting code(up to 25% data bit error)
   7. AT command configure data transmission
   8. RT command remote control data transmission
   9. Interchangeable air and ground 433MHz modules
   10.  Micro-USB port
   11. 6-position Molex connector
   12. 500 mW maximum output power (adjustable)
   13. SMA connector
   14. 2-way full-duplex communication through adaptive TDM
   15. UART interface
   16. Transparent serial link
   17. Open-source SIK firmware
   18. Configurable through *Mission Planner and *APM Planner
   19. Based on the HM-TRP wireless module, with Si1000 8051 microcontroller and Si4432 wireless module

Package Includes:

2 x Telemetry Module.

2 x 2.5dbi Antenna.

1 x Micro USB OTG cable.

Set of Connection Cable.

The X8R is in a smaller package than the previous 8 channel receivers but has so much more capability. The new Smart Port supports the new hub-less sensors as well as the older hub analog sensors.

The X8R supports 8 standard servo outputs, and you can access all 16 channels by using the Sbus line with Sbus supported servos or use a FrSky S.BUS Decoder for the full 16 channels. Or you can use 2 X8R receivers in combination and the channels will sync 1-8 on the first and 9-16 on the second.

The X8 protocol is also backward compatible! In D8 mode it works with the DHT, DJT, DFT, and DHT-U transmitter modules. In this mode, you only have access to 8 channels but you still get to use the new Smart Port and digital sensors! And even cooler is the new antenna design “PCB” it reports up to a 20% gain in range over their older antennas. And the X8R is Firmware Upgradeable!

This is the perfect receiver for the FrSky Taranis, with its built-in XJT Module or any of the D8 systems to take advantage of the new digital Smart Port sensors.

Features:

1. With RSSI PWM output (0~3.3V)
2. Parallel two X8R to become a 16 channel receiver.
3. SmartPort enabled realizing two-way full-duplex transmission.
4. More number of channels: 1~8ch from conventional channel outputs 1~16ch from SBUS port or combine two X8R to become a 16 channels receiver.
5. All 16 channels require the FrSky Taranis or the XJT module bound in D16 mode. For 8 channels in D8 Mode, you can use the FrSky Taranis or XJT DJT DFT DHT and DHT-U modules.

Package Includes:

1 x FrSky X8R 8/16ch Full Duplex Telemetry Receiver