- 35% Off Industrial and Drone Parts.
- Free carbon neutral shipping on India orders ₹ 2000+.
End of Time:
:
:
:
0
0 items
₹0.00
No products in the cart.
- Main chip: ESP32-WROVER-B, SIM7000G
- Flash Memory:4M Flash / 8M PSRAM
- Interface: USB, SD Card, Solar Input interface
- Car Clock:40MHz
- Button: Reset, Power switch
- SIM Card Size: Nano SIM Card
- Antenna: SIM Antenna,GPS Antenna
- Operating Temperature Range:-40-85 degrees
Add to Wishlist
Add to Wishlist
- Main chip:ESP32 WROVER-B
- Interface: USB, SD Card, Solar Input interface
- Car Clock:40MHz
- Button: Reset, Power switch
- Antenna: SIM Antenna,GPS Antenna
- Operating Temperature Range:-40-85 degrees
Add to Wishlist
Add to Wishlist
- Very low power logging is supported
- Built-in MCP73831 single cell LiPo charger
- Current consumption
- ~20mA (Run)
- ~80µA (Sleep)
- ~18µA (Deep Sleep – regulator shut down)
- LEDs
- Power
- LiPo charge indicator
- Serial Tx and Rx
- Status
Add to Wishlist
Add to Wishlist
- Power amplifier chip NS4168
- I2S serial digital audio input interface
- Support a wide range of sampling rates: 8kHz~96kHz
- Automatic sampling rate detection, adaptive function
Add to Wishlist
Add to Wishlist
- Support type:16G FAT/FAT32 MicroSD
- Compatible with ATOM Matrix/ ATOM Lite
- Up to 16G TF card
- FAT/FAT32 format
Add to Wishlist
Add to Wishlist
- ESP32 Standard wireless functions WiFi, Bluetooth
- Internal 4M Flash
- Low Power Display
- 180-degree viewing angle
Add to Wishlist
Add to Wishlist
- User name and model setup can be saved (up to 15 aircraft)
- RSSI and Telemetry
- Adjustable display brightness and contrast
- Multiple alarms
- Servo reversing and end-point adjustment
- Adjustable servo travel limit (prevents pushrod jamming)
Add to Wishlist
Add to Wishlist
- Operating Voltage (VDC):7.4-12 V
- No of channels:12
- User name and model setup can be saved (up to 15 aircraft)
- RSSI and Telemetry
- Adjustable display brightness and contrast
- Multiple alarms
Add to Wishlist
Add to Wishlist
- Input Voltage:3-5.5 V
- Flash Memory:8 MB
- Powered by RP2040
- User controllable RGB LED
- USB-C connector for power, programming, and data transfer
Add to Wishlist
Add to Wishlist
- Model: R9 STAB OTA
- Numbers of Channel: 8/16CH (CH16 outputs RSSI)
- Operating Voltage: DC 3.5V~10V
- Operating Current: 140mA@7.4V
- Measuring range of gyroscope: ±2000dps
- Measuring range of acceleration: ±4g
Add to Wishlist
Add to Wishlist
- Open-source operating system
- Default Operating Mode: Mode 2 (Left-Hand Throttle).
- This Remote comes with 2 x 18650 battery holder for power supply
- It is also compatible with a 2S battery with 3pin JST (XH) connector ( Battery Slot size is 92 x 57 x 18 mm (L x W x H)
- Installed with ACCESS protocol
- High-speed module digital interface
- Supports spectrum analyzer function
- Supports wired training function
- Haptic vibration alerts and voice speech outputs
Add to Wishlist
Add to Wishlist
- Model: Frsky R9 M Lite Pro Receiver
- Channel: 16CH
- Supports: Spectrum analyzer
- RF Operating Frequency: 868MHz / 915MHz
- RF Power (Non-LBT): 10mW / 100mW / 500mW / 100mW~1W
Add to Wishlist
Add to Wishlist
- Input Voltage (V):3.3V@600mA
- Processor: Kinetis KL26 Arm® Cortex®-M0+ MCU
- Maximum Clock Frequency (MHz):48
- Flash Memory:128kB
- SRAM:16kB
- Dimension:95x38x10 mm
- Weight:21 gm
Add to Wishlist
Add to Wishlist
- Working voltage: 3.3V
- Input voltage: 3.3V~5V
- Support electric current of low power consumption: 10 μA
- Support maximum discharge current: 600mA
- Quick Response(the top frequency is 400KHz)
- Cost-effective
- Small size, convenient to install
Add to Wishlist
Add to Wishlist
- Compatibility: ACCST D16 and ACCESS receivers Communication Protocol:ACCST D16 /ACCESS Feel Free to Choose
- Classic Taranis form factor design Easy launch momentary button
- Program navigation button High-speed module digital interface
- Installed with ACCESS protocol Supports spectrum analyzer function
- Supports SWR indicator warning G9D potentiometer gimbal Supports wired training function
Add to Wishlist
Add to Wishlist
- WiFi+Bluetooth 4.0 Dual-mode Module
- GDI Display Port, easy to connect
- Operating Voltage: 3.3V
- Input Voltage: 3.3V~5.5V
- Support Low-Power: 10uA
- ESP32 Dual-core low power main controller, 10uA power consumption
Add to Wishlist
Add to Wishlist
Basic Components – Resistors | Capacitors | LEDs | Inductor | Varistor | Breadboard | Oscillator
Important links
Need Help?
+91 7231900002 (whatsapp)
Monday – Friday: 9:00-20:00
Saturady: 11:00 – 15:00
Customer Service
- -5% for all order in this week Shop now
- Free delivery for all orders over ₹ 2000