ARM Microcontroller
MICROCHIP Evaluation Board, SAMA5D4 Xplained Ultra, Cortex-A5, SAMA5D4 MPU
Out of stock
| Microprocessor |
SAMA5D44 Cortex-A5 |
|---|---|
| Memory |
1 EEPROM with a unique MAC address and serial number ,512MBytes DDR2 memory ,512MBytes NAND Flash memory |
| Connectors |
LCD connectors One HDMI connector Three USB connectors (2 Host and 1 Device) |
| Ethernet |
10/100 Ethernet MAC with PHY and connector |
| MicroSD slots |
1x SD/eMMC 1x MicroSD slots |
| Compatible |
Arduino R3 Shield and Xplained Wing compatible expansions headers |
MICROCHIP Evaluation Kit, Xplained Pro, SAM4SD32 MCU, On Board Embedded Debugger, Extension Boards
Out of stock
NXP Development Board, LPC11U68 MCU, JTAG Debugger, LPCXpresso Arduino UNO Expansion Connectors
Out of stock
| Operating Temperature Range (°C) |
40 °C to 105 °C |
|---|---|
| Single power supply |
2.4 V to 3.6 V |
| System |
ARM Cortex-M0+ processor (version r0p1) ,running at frequencies of up to 50 MHz with single-cycle multiplier and fast single-cycle I/O port. ARM Cortex-M0+ built-in Nested Vectored Interrupt Controller (NVIC). AHB Multilayer matrix. System tick timer. Serial Wire Debug (SWD) and JTAG boundary scan modes supported. Micro Trace Buffer (MTB) supported. |
| Memory |
Up to 256 KB on-chip flash programming memory with page erase. Up to 32 KB main SRAM. Up to two additional SRAM blocks of 2 KB each. Up to 4 KB EEPROM. |
| ROM API support |
Boot loader. USART drivers. I2C drivers. USB drivers. DMA drivers. |
STMICROELECTRONICS Development Board, STM32F103RBT6 MCU, On Board Debugger, Arduino Uno & Morpho Connectivity
Out of stock
STMICROELECTRONICS Development Kit, STM32F072RB MCU, On-Board ST-LINK/V2, ST MEMS Gyroscope, Extension Header
Out of stock
| Model |
STM32F072RB MC |
|---|---|
| Product Type |
STMICROELECTRONICS Development Kit |
| RAM |
16 KB of SRAM in an LQFP64 package |
| Flash Memory |
128 KB of Flash memory |
| System requirements |
Windows PC (XP ,7 ,8) |
| Operating Voltage(V) |
3V and 5V |
| Board power supply |
Through USB bus or a external 5 V supply voltage |
| Gyroscope |
L3GD20 ST MEMS motion sensor 3-axis digital output gyroscope |
| Six LEDs |
LD1 (red/green) for USB communication LD2 (red) for 3.3 V power on Four user LEDs: LD3 (orange) ,LD4 (green) ,LD5 (red) and LD6 (blue) |
| Buttons |
Two push-buttons (user and reset) |
STMICROELECTRONICS Development Kit, STM32F100RB MCU, On-Board ST-Link with Selection Mode Switch, Extension header
Out of stock
STMICROELECTRONICS Discovery Board, STM32F429ZI MCU, 2.4″ QVGA LCD, 3-axis MEMS Motion Sensor
Out of stock
STMICROELECTRONICS Discovery Kit, For Foundation Line MCU, Various Sensors, Indicator LEDs
Out of stock
STMICROELECTRONICS Development Board, Nucleo, STM32 MCUS, Arduino Uno Compatible, On-Board Programmer
Out of stock
STMICROELECTRONICS Discovery Kit, STM32F769NI MCU, On-Board ST-LINK/V2-1, 4″ Capacitive Touch LCD Display
Out of stock
STMICROELECTRONICS Development Board, STM32L031K6 MCU, On-Board Debugger, Arduino Compatible
Out of stock
STMICROELECTRONICS Expansion Board, IPS160HF, STM32 Nucleo Development Board
Out of stock