pH
Mikroe DIFF PRESS CLICK
Out of stock
AFM0200 Micro Flow Sensor
Out of stock
TE CONNECTIVITY Flow Switch, FCS Series, 0.1 l/min to 1.1 l/min, 9.525 mm Port Size, SPST-NO, 250 Vac, 1 A, PPS
Out of stock
TE CONNECTIVITY Flow Switch, FCS-01, 0.6 l/min, 3/8″ BSP Port Size, SPST-NO, 250 Vac, 1 A, Noryl
Out of stock
TE CONNECTIVITY Flow Switch, FS-10, 0 ml/min to 500 ml/min, 15 mm Port Size, 10 bar, SPST-NO, 300 Vac, 1 A
Out of stock
TE CONNECTIVITY Flow Switch, FS-90/1, 3 l/m, 15 mm Port Size, 10 bar, SPST-NO, 250 Vac, 1 A, Copper Pipe
Out of stock
RENESAS Flow Sensor, FS1012 Series, Gas, MEMS, 10000 SCCM, 3 V to 5 V, mV Output
Out of stock
DFRobot Gravity Industrial Grade Analog Electrical Conductivity Sensor PRO (K=1)
Out of stock
| Supply Voltage |
3.3-5.0V |
|---|---|
| Output signal |
0-3V |
| Probe Type |
Industrial Grade |
| Cell Constant |
K=1 |
| Temperature Detector: |
PT1000 platinum resistance thermometer |
| Maximum Range |
1-2200μs/cm |
| Practical Range |
100-2000μs/cm |
| Operating Temperature |
0 – 100℃ |
| Pressure Resistant |
0.5MPa |
| Waterproof Level |
IP68 |
| Board Size |
42mm X 32mm / 1.65in X 1.26in |
DFRobot Gravity Lab Grade Analog Electrical Conductivity Sensor / Meter(K=10)
Out of stock
DFRobot Gravity Lab Grade Analog pH Sensor/Meter Kit V2
Out of stock
| Supply Voltage |
3.3~5.5V |
|---|---|
| Output Voltage |
0~3.0V |
| Probe Connector |
BNC |
| Signal Connector |
PH2.0-3P |
| Measurement Accuracy |
±0.1 at 25℃ |
| Probe Type |
Laboratory Grade |
| Detection Range |
0~14 |
| Temperature Range |
5~60°C |
| Zero Point |
7±0.5 |
| Response Time |
<2min |
| Internal Resistance |
<250MΩ |
| Probe Life |
>0.5 years (depending on the frequency of use) |
| Dimension |
42mm x 32mm/1.66 x 1.26in |
DFRobot Gravity Lab Grade Analog Electrical Conductivity Sensor /Meter V2 (K=1)
Out of stock
| Supply Voltage |
3.0~5.0V |
|---|---|
| Output Voltage |
0~3.4V |
| Probe Connector |
BNC |
| Probe Type |
Laboratory Grade |
| Cell Constant |
1.0 |
| Support Detection Range |
0~20ms/cm |
| Recommended Detection Range |
1~15ms/cm |
| Temperature Range |
0~40°C |
| Probe Life |
>0.5 years (depending on the frequency of use) |
| Cable Length |
100cm |
| Signal Connector |
PH2.0-3Pin |
| Measurement Accuracy |
±5% F.S |
| Board size |
42mm x 32mm/1.65in x 1.26in |
DFRobot Gravity CL2 Sensor (Calibrated) – I2C & UART
Out of stock
| Model |
Gravity: O2 Signal Conversion Board |
|---|---|
| Detection Gas |
Chlorine (CL2) |
| Detection range |
0~10ppm |
| Working Voltage |
3.3～5.5V DC |
| Working Current |
＜5mA |
| Output Signal |
I2C ,UART (0~3V) ,analog voltage |
| Compatibility |
Arduino ,ESP32 ,Raspberry pi |
| Lifespan |
＞2 years (in the air) |
| Adapter Plate Size |
37 x 32mm |
| Working Humidity Range |
15～90%RH (non-condensing) |
| Working Temperature Range (°C) |
-20～50℃ |