Waveshare 7inch Capacitive Touch Display for Raspberry Pi, with 5MP Front Camera, 800?480, DSI

This 7″ DSI display for the Raspberry Pi comes with a front built-in 5MP OV5647 camera module which can be used with the same commands as the official Raspberry Pi camera module.

The display is a 7″ panel offering up to 5-point capacitive touch (OS dependant) and 800×480 resolution. The screen connects to your Raspberry Pi via the same DSI ribbon cable and 5V/GND jumper wire method as the official Raspberry Pi display. This leaves the majority of your GPIO pins free for your project.

The display backlight can be adjusted via software/touch and the generous outer bezel also makes this a great option for integrating into your project enclosure. The included camera module connects to your CSI port via the included ribbon cable and uses a 5MP OV5647 sensor which can shoot images up to 2592×1944 and videos up to 1920x1080P @30FPS (full specs below).

The display comes with fixings, ribbon cables and jumper wires.

Features: 

1. 7″ DSI display for Raspberry Pi
2. Supports Raspberry Pi OS driver-free
3. Compatible with Raspberry Pi boards with a DSI connector – Raspberry Pi 4, 3B+, 3A+, 3
4. 800×480 resolution
5. 5-point capacitive touch
6. 5MP OV5647 Camera
7. CSI interface, supports 1920x1080p@30, 1280x720p@60, 640×480p@60, 640×480p@90
8. I2C touch port
9. Toughened glass panel
10. Supports backlight adjustment via software
11. DSI interface, refresh rate up to 60Hz
12. Low power consumption

Package Includes:

1 x 7inch DSI LCD

1 x FPC 15PIN 1.0 pitch 50mm (opposite sides)

1 x FPC 15PIN 1.0 pitch 120mm (opposite sides)

1 x 2PIN wire 10cm

1 x Screws pack